Aj-antunes-co DFW-150 9100805 Manuel d'utilisateur télécharger pdf (Page 11)

P/N 1010966 Rev. G 08/12

TROUBLESHOOTING

Problem Possible Cause Corrective Action

Control Display is blank

(Power is on but indicator light

is off).

The power cord is not correctly plugged in. Plug the power cord into the appropriate outlet.

The power cord and/or electrical plug is damaged. Inspect electrical wire, plug, and receptacle.

The main electrical panel circuit breaker is off or has

tripped.

Reset circuit breaker. Contact your maintenance per-

son or Authorized Service Agency if it trips again.

Power Switch is inoperable. Contact your maintenance person or Authorized

Service Agency for service.

Control Display is blank

(Power is on and indicator light is on).

Control Board is inoperable. Contact your maintenance person or Authorized

Service Agency for service.

Transformer is inoperable.

Loose, burnt, or broken wires in circuit.

Unit does not heat up

(Power is on and indicator light is on).

Hi-Limit Thermostat is tripped or inoperable. Reset the Hi-Limit Thermostat according to the

Operation section of this manual. If the Hi-Limit

Thermostat requires continuous resetting, contact

your Authorized Service Agency for service.

Transformer is inoperable.

Solid State Relay is inoperable.

Thermocouple is inoperable.

Control Board is inoperable.

Steam Generator is inoperable.

Loose, burnt, or broken wires in circuit.

The unit’s main electrical panel circuit

breaker trips.

Damaged receptacle, plug, or cord; a loose connec-

tion; or an internal component failure.

Turn the unit off, allow it to cool to room tempera-

ture, and then restart the unit. Contact your main-

tenance person or Authorized Service Agency if the

condition repeats.

Circuit breaker is overloaded.

Water leaking inside electrical housing. Pinhole leak in robber hoses. Replace hoses.

Loose or damaged water line tubes and/or fittings

inside electrical housing.

Tighten or replace tubes and/or fittings.

“ERR” appears on the Control Display. Programming and or SHO and H2O values were

adjusted/changed improperly.

Reset the Control Board as described in the

Programming section of this manual. See Fault

Codes.

WARNING

To avoid possible personal injury and/or damage to the unit, inspection, test, and repair of electrical equipment should be performed by qualified

service personnel. The unit should be unplugged when servicing, except when electrical tests are required. Use extreme care during electrical circuit

tests. Live circuits will be exposed. If the troubleshooting steps listed below do not solve your machine’s problem, contact an Authorized Service

Agency for further assistance.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Aj-antunes-co DFW-150 9100805 Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Cuiseur à vapeur Aj-antunes-co DFW-150 9100805