Aj-antunes-co VS-200ADB 9100230 Manuel d'utilisateur Page 10

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 20
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 9
10
VARIETY STEAMER
P/N 1010649 Rev. G 03/12
A.J. Antunes & Co.
Daily Maintenance
NOTE: Frequency of cleaning is determined by
water conditions, usage and water filter systems.
1. Turn the power off, unplug the power cord, and
allow the unit to cool down.
2. Check the rear water quick disconnect fitting and
all hose clamp connections for leaks. Tighten all

 

water, rinse, and allow to air dry.
4. Move the Locking Lever to the unlocked position.
Remove the Black Manifold Plate, the large black

5. Remove the Spray Tube by carefully lifting the
loose end and gently twisting and pulling it out of
the steam generator hole.
 

Manifold as well as the six holes in the Spray
Tube. Then wash all items in hot soapy water,
rinse, and allow them to air dry.
7. Reinstall the Spray Tube into the Steam

 
large black O-ring and reinstall the O-ring onto
the Manifold Plate.
 
that light is visible through all of the holes. If not,
use the punching tool to clean any clogged holes.
10. Seat the Manifold Plate on the Generator and pull
the Locking Lever forward to lock the plate.
11. Check that the Water Pressure Regulator is

2
or

12. Re-install all parts and accessories. Plug power
cord into electrical outlet.
MAINTENANCE
WARNING
Turn the power off, unplug the power cord, and
allow the unit to cool down before performing any
service or maintenance on the unit.
CAUTION
Do NOT use a sanitizing solution or abrasive
materials. The use of these may cause damage to
the stainless steel finish.
CAUTION
If a chemical cleaner is used, be sure it is safe to
use on cast aluminum. Observe all precautions
and warnings on product label.
CAUTION
Failure to regularly and/or properly clean this
equipment may damage it or cause the user
bodily injury.
CAUTION
Chlories or phosphates in cleaning agents such
as bleach, sanitizers, degreasers, or detergents
could cause permanent damage to the stainless
steel equipment. The damage is ususally in the
form of discoloration, dulling of metal surface fin-
ish, pits, voids, holes, or cracks. This damage is
permanent and not covered by warranty. The fol-
lowing tips are recommended for maintenance of
your stainless steel equipment:
• Alwaysuseasoft,dampclothforcleaning,
rinse with clear water, and wipe dry. When
required, always rub in the direction of the
metal polish lines.
• Routinecleaningshouldbedonedailyusing
soap, ammonia detergent, and water.
• Stainsandspotsshouldberemovedusinga
vinegar solution.
• Fingermarksandsmearsshouldberemoved
using soap and water.
• Hardwaterspotsshouldberemovedusinga
vinegar solution.
Vue de la page 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Commentaires sur ces manuels

Pas de commentaire